WiFiX Outdoor Enclosure Cable Gland – Heavy Duty
LTEFix.com’s Outdoor Enclosure Cable Glands are made for use with outdoor enclosure installations to seal up your valuable cellular and wifi equipment completely. Using these cable glands with our WiFiX Medium Router PCB Enclosure Kit keeps your equipment completely sealed, dry, and safe from pests in all weather conditions.
This “Heavy Duty” version has the same 20mm bore size but with a beefier hold nut and clamp tip and insert. The clamping insert has a larger bore than our standard version but will clamp all the way down onto ethernet cables and antenna cables for a full seal. The clamping tip also uses a finer thread pattern for a more powerful, yet easy to turn and set, clamping.
Note: Ensure that the relative humidity is low when assembling your enclosure as to not trap in excessive moisture that may “sweat” inside the enclosure during environmental temperature fluctuations. Sometimes adding a silicon desiccant bag to the inside of the enclosure may be necessary to absorb post assembly moisture from the inside of the enclosure.
With an overall inside diameter bore of 19/32″ (15mm), there is plenty of space to pass through a standard size RJ45 ethernet plug. The included soft rubber one piece gland can be stretched over your ethernet cabling ends, antenna connectors, or any wiring you wish to install through your outdoor enclosure for direct wiring to your cellular, or wifi, equipment. Typical installation use is for ethernet and antenna cabling, though power cabling and any other cabling you can squeeze though will be sealed. The rubber sealing insert can be carefully split if needed, and still seal properly.
See the Assembly Instructions tab for visual instructions on assembly.