Description
WiFix DM25X14 is a WiFi | 4G | LTE MIMO 2×2 X-Polarity 14dBi directional panel antenna and enclosure
The DM25X14 WiFi 4G LTE 14dBi MIMO antenna is a high quality directional antenna with dual X polarity (slant ± 45°), designed to accommodate devices at MIMO 2×2. The antenna is also used for PTP (Point-to-Point) and PMP (Point-to-Multipoint) as a client antenna.
The DM25X14 MIMO antenna is a narrow band directional panel antenna engineered to improve signal strength and reception over the 2300MHz to 2700MHz frequency range. It is ideal for rural, suburban and other locations where the mobile signal is poor or less than desirable, or where a better signal is required to take advantage of carrier aggregation. Its narrow range targets LTE FDD Band 7 and TDD Bands 38, 40 and 41, Bluetooth and WLAN 2.4GHz (802.11 b/g/n). Its small dimensions and aesthetic appearance accommodate installations at most any location, even for high demanding applications and customers.
The antenna component and circuitry are integrated within our top quality WiFix Medium enclosure system.
WiFix Medium Enclosure
WiFix Medium Inside Specs
The system includes 2 x SMA Female connectors within the enclosure, mounted directly to the antenna’s backing plate. U.FL to SMA Male jumper cables (pigtails) can easily connect the antenna system to a modem (i.e., a Sierra Wireless modem), or Wi-Fi card. Similarly, a SMA Male to SMA Male (or RP-SMA Male) pigtails may connect a router’s 4G LTE antenna connectors directly to the antenna.
SMA Female Antenna Connector
While the DM25X14’s design allows easy installation of a router or PCB inside the antenna enclosure by installing a RJ45 waterproof IP67 cable gland/jack in the single cutout hole.
WiFix comes with a single cutout hole
The system may also be used as a stand-alone antenna. The cutouts provide locations where additional holes may be drilled to install SMA, RP-SMA, Type N, or another other bulkhead connectors.
When installing as a stand-alone antenna for use with Type N Male connectors for Low Loss Cables, the cutout on the far right would be drilled to accommodate the Type N Female bulkhead adapter.
WiFix with dual cutout holes
Two SMA Male Right Angle to Type N Female O-Ringed Bulkhead Connector (as shown below) pigtails may then be installed through the two cutouts–which would connect to the Low Loss Cable.
N Type Female Bulkhead to SMA Male (Right Angle) Pigtail
The WiFix DM25X14 is suitable for both indoor and outdoor (IP67) installations, both wall and pole mask mounting.
Wall and pole installations – SMA female to Type N Female bulkhead connectors
WiFix systems are engineered of UV resistant ABS plastic material that is resistant to extreme weather conditions like rain, snow and humidity. They can safely operate in temperatures ranging from -40°C up to 80°C. WiFix designed sealing systems guarantees a waterproofed level of IP67.
WiFix Systems are IP67 Waterproof
The WiSecure mounting system is engineered to couple stability and attractiveness in one product. Its design is made of a special fiberglass reinforced polyamide plastic, which is super rigid–even in extreme weather conditions. Its innovative design and composite makeup, compared to metal brackets, offers better performance and a rust free life-time. WiSecure further enables the antenna position and aligning in two separate polarization settings.
WiSecure Antenna Mounting System
WiSecure Antenna Mounting System
Reviews
There are no reviews yet.